Ball Bearing Turbochargers (June 01, 1999)

We are pleased to announce that we can now offer a range of ball bearing turbochargers and CHRAs for special applications.

Ball bearing turbos offer exceptionally quick response times with improved shaft stability. Combined with the latest specially adapted GT series turbine wheel designs and specially developed compressor wheels, we have a range of turbos which spans T25 size right through to GT40 compressor wheels and all mounted on T25 size center housings. Go to following page to see turbos available:

www.turbomaster.info/eng/applications/ball_bearings_turbosGT.php

The CHRAs are all based around the familiar T25 size center housing, allowing the use of a variety of different housings and adaptor rings. Also shown are the approximate power outputs, in Horsepower, that the units are suitable for. This is of course, for guidance only; actual power outputs will vary according to many factors such as engine design size.

Ball bearing units are available to any who wishes to undertake the matching and fitting of theses units. Regret that we can not offer any further assistance on individual projects.

No warranty is offer on these turbos, but they are built in our Japanese factory to extremely tight tolerances, assuring maximum service life performance. Japan report almost zero field returns to date.

If you want to take advantage of this leading edge technology, don't hesitate to contact us.

Trevor Cass
Product Support Engineer
Allied Signal Turbocharger Aftermarket